[En-Nut-Discussion] Re: uart1 physical connection

[Cosmin Buhu]

>I couldn't find any information on where the connection to uart1 is
>located on the 1.3 rev-f board. So how should I connect this second
>port?

RS232 levels on pin 7,8 of the 9 pin D connector. You need to
solder R16 and R17 (short the pads) on the bottom of the board.
Or TTL levels on pin 52, 53 of J5, expansion connector (R16, 17 off).
Be careful with the soldering iron on the pads, they are going
off very quickly. It wasn't a very good idea to use short pads
for people that are switching frequently port D for second uart 
and general IO, or use RS232 levels and TTL levels. My board is 
already suffering.


Cosmin

Film & TV Extras urgently required in your area - See Yourself in major Films & TV? Call 0907 1512440 to Register. calls cost 150pm