[En-Nut-Discussion] Check power and cable

[filipa]

Dear Brett,

I have checked the cable and the power. I've tried the cable with another
ethernut board, and there were no problems while programming it.

I think, there is something wrong with the programming interface.

Cheers,
Can.

-----Original Message-----
From: en-nut-discussion-bounces at egnite.de
[mailto:en-nut-discussion-bounces at egnite.de] On Behalf Of Brett Abbott
Sent: Tuesday, December 30, 2003 6:37 AM
To: en-nut-discussion at egnite.de
Subject: [En-Nut-Discussion] Check power and cable

Can

If you are using the Atmel JTAG unit, check for a micro
crack in the flex cable....  If not, look/test for broken
solder joints/wires.

Cheers
Brett


Message: 3
Date: Mon, 22 Dec 2003 16:01:08 +0200
From: "M. Can Filibeli" <filipa at superonline.com>
Subject: [En-Nut-Discussion] Programming the AVR board
To: <en-nut-discussion at egnite.de>
Message-ID:
<20031222140104.9185B2F429C at p15095813.pureserver.info>
Content-Type: text/plain; charset="us-ascii"

Hi;

 

While I was programming the ethernut board with ICC today,
"Cannot determine
the AVR device type. Please check power and cable." message
appears. The
program I have burned 2 days ago is still working. However I
cannot program
the Ethernut Board using in system programming. Is something
wrong with the
programming interface?

 

Regards,

Can Filibeli.

_______________________________________________
En-Nut-Discussion mailing list
En-Nut-Discussion at egnite.de
http://www.egnite.de/mailman/listinfo.cgi/en-nut-discussion