[En-Nut-Discussion] Problem programming EtherNUT - Newbie assistance required.

[Grahame Kelly]

Hi All.

Some time ago i purchased a EtherNUT developers kit. I hadn't programmed it
as I had several AVR-M16 projects to finish first, using my STK500 development
board. I run only Linux and have had no problems (re)programming M16, 2313 and
M163 chips on the STK500. 

However, with the EtherNUT developers kit, I have been unable
to get the "make burn" to work at all - always get "Programmer is not responding"
error message. I can verify that on power up the doggle yellow led blinks as if
initialising correctly, and the connector in correctly seated and the EhterNUT board
works fine with its supplied basemon & httpd program.

I have looked through the mail archives but haven't found anything which addresses
my problems. Can someone assist me, I want to get the EtherNUT incorporated
into our new controllers.

Thanks.
Grahame
<grahame at wildpossum.com>