[En-Nut-Discussion] EtherNUT-3.3.0 Example Problems - EtherNUT Newbie

[Harald Kipp]

Grahame,

For windows, I'd be sure that you are using hyperterm.
This program is so incredibly buggy.

As you are using Linux, I'd suggest to check the
tty settings: 8-bit, no parity, 1 stopbit is
required.

Characters above 127 doesn't display correctly, so
it looks like 7 bit to me.

Harald

At 16:31 15.10.2003 +1000, you wrote:
>Hi All.
>
>I am having problems with two things (Linux Environment):
>
>1> "make" does not generate a new urom.c (all output goes to the screen),
>but crurom works correctly for those make where a new urom.c should
>be generated. makefile itself looks OK.
>
>2> Major problem is Serial output seems to be corrupted. For example on 
>loading
>the httpserv.hex - "make burn" verifies OK, but the following appears
>on the terminal screen. Note my IP addr is 10.10.10.99
>
>N++/OS 3.3.0.1 HTTP D#+ÄÅ...10.10.10.99 _#<
>[1] CÄÅÅ+, 23461 <+_ °_
>[1] D_ÄÅÅ+
>[2] CÄÅÅ+, 23461 <+_ °_
>[2] D_ÄÅÅ+
>[3] CÄÅÅ+, 22943 <+_ °_
>[3] D_ÄÅÅ+
>
>The other program exhibit the same problems. The original
>basmon worked without any uart problems but after re programming
>EtherNUT I haven't been successful in getting the UART0 to work
>reliably.
>
>Can anyone offer suggestions on what to try?
>Thanks Grahame
>_______________________________________________
>En-Nut-Discussion mailing list
>En-Nut-Discussion at egnite.de
>http://www.egnite.de/mailman/listinfo/en-nut-discussion