[En-Nut-Discussion] Poorman Ethernut

[Cosmin Buhu]

    You won't be able to build something with PCI bus with
microcontrollers in such range as Mega128 or even higher,
because of PCI bus speed, at least.

Cosmin

PS My question about how to enable 64KB SRAM on
ethernut - without ether, didn't reach the list ?


----- Original Message -----
From: "bino" <bino at indoakses-online.com>
To: <en-nut-discussion at egnite.de>
Sent: Tuesday, October 05, 2004 4:47 AM
Subject: [En-Nut-Discussion] Poorman Ethernut


>
> Dear All.
> I'm just joining this group .. and yes i'm a total newbie.
>
> 1. Is there any searchable archieve of this group ?
> 2. where can I got a schematic or board design of ATMega-128 evaluation
> board ?
>
> 3. Is there any Poorman-ethernut using PCI (rtl8139) rather then the ISA ?
>
> I'm in indonesia .. and the RTL-8139 card is the easiest and cheapest card
I
> can get .. and in case I want to start playing danger to build complete
> EtherNut 1.3 or 2.x I hope I can pull this ethernet chip from the card.
> It's impossible to buy any Ethernet controller chip in my area.
>
> Sincerely
>  -bino-
>
> Sincerely
>  -bino-
> _______________________________________________
> En-Nut-Discussion mailing list
> En-Nut-Discussion at egnite.de
> http://www.egnite.de/mailman/listinfo.cgi/en-nut-discussion