[En-Nut-Discussion] RTL8019AS configuration modes

[Leo Hendrawan]

Hello,

i still confused about the RTL8019AS configuration modes (jumper,
jumperless, and PnP).
If i used the jumper mode (i.e. JP pin pulled high) then should i
configure the I/O base, network medium type, etc. through the
memory interface configuration pins (IOS3-0, PL1-0) or i still can
do it through registers configuration?

end if i select the jumper mode (no EEPROM) should i tie the EEDO pin to
the ground? because i read it at http//www.darksmile.net/pic

best regards,


Leo Hendrawan
 13200005
 at 12:04 Oct 12