[En-Nut-Discussion]"make" problem with AVR-icc

[Hans de Roode]

Harald,
Currently I'm using Codevision, can you give some advantages of ICCAVR,
or why you choose for ICCAVR?

Kind regards, Hans
New Zealand


-----Original Message-----
From: Harald Kipp [mailto:harald.kipp at egnite.de] 
Sent: Wednesday, 15 September 2004 7:45 p.m.
To: Ethernut User Chat (English)
Subject: Re: [En-Nut-Discussion]"make" problem with AVR-icc


Richard told me, that the command line had been always disabled with the
demo version.

I'm puzzled, but Michael told me, that the compiler behaves different
with the dongled version. The command line still works after removing
the dongle until reboot. That may have caused my confusion.

Harald

At 19:20 14.09.2004 +0200, you wrote:
>Michael,
>
>that's completely new too me. May this have changed
>during the last months? Or could it be, that only
>the linker refuses to work.
>
>I'm almost sure, that libraries could have been created
>with the demo.
>
>Harald
>
>At 19:06 14.09.2004 +0200, you wrote:
>>Hello Hans,
>>
>>if you have only a demo version of the ICCAVR,
>>you can not use the command line mode.
>>
>>You need a license to work with it. But it is possible
>>that Harald get more information from ImageCraft.
>>
>>Regards,
>>
>>Michael
>

_______________________________________________
En-Nut-Discussion mailing list
En-Nut-Discussion at egnite.de
http://www.egnite.de/mailman/listinfo.cgi/en-nut-discussion