[En-Nut-Discussion] Hardware and fuse info

[Bas Nedermeijer]

Hello,

i just unwrapped an ethernut 2.1 board, and hooked it up according to the 
manual. I used 9v w/ the barrel connector. The manual says it is protected 
by a fuse (F1), which blew after about 10 secs. So i replaced it with a 
spare fuse, and started from 3v to 7.5, after which the red led became 
active again. But now the replacement fuse shines a little bit, and i dont 
too much about hardware, to determine if that is normal operation 
procedure   :)

So i unplugged the device to be on the safe side.

I would welcome some advice.

 	greetz, Bas Nedermeijer