[En-Nut-Discussion] Success!!! Realtec driver for GPIO access

[Zachary]

Hi Henrik, thank you for your answer! It help me a lot, bacause as I change 
the nicrtl.c to make it works with GPIO to access realtek chip, I was 
thinking it has an error, allthough the change is ridiculous simple.

regards

/Zach


----- Original Message ----- 
From: "Henrik Maier" <hmlists at focus-sw.com>
To: "Ethernut User Chat (English)" <en-nut-discussion at egnite.de>
Sent: Thursday, November 02, 2006 5:32 AM
Subject: Re: [En-Nut-Discussion] Success!!! Realtec driver for GPIO access


> Yes, if the INT line of the RTL8019AS is directly connected to the 
> ATmega128 you need the edge triggered mode otherwise the polarity of the 
> INT signal is wrong. The edge triggered mode allows configuration of the 
> polarity, the level mode doesn't.
>
> Henrik
> http://www.proconx.com
>
>
> Zachary wrote:
>> Thank you for yout answer.
>>
>> If I understood, if the hardware have the inverter this is an option if 
>> the hardware does not have one like mine, so I need to set this option, 
>> Is this true?
>>
>>
>> Ethernut is amazing, I am having a ping answer in 1,6 ms.
>>
>> regards
>>
>> /Zach
>
> _______________________________________________
> En-Nut-Discussion mailing list
> En-Nut-Discussion at egnite.de
> http://www.egnite.de/mailman/listinfo.cgi/en-nut-discussion
>
>
> -- 
> No virus found in this incoming message.
> Checked by AVG Free Edition.
> Version: 7.1.409 / Virus Database: 268.13.21/511 - Release Date: 1/11/2006
>
>