[En-Nut-Discussion] Jumper configuration for hardware handshake

[José Vallet]

Hello

In the Hardware User's manual of the Ethernut 2, in the Jumper 
Configuration section there is a small "issue".

The 4th picture is about jumper configuration for using hardware 
handshake (RTS and CTS). While the texts says that

"If your application requires hardware
handshake via RTS/CTS, then connect JP1
pins 4 and 6 and pins 5 and 7. The picture
on the right shows the hardware handshake
configuration for UART0."

the picture displays the pins 4 and 6 and pins 7 and 8 connected 
(instead of 5 and 7). Checking in the the nutconf it seems that the 
default configuration is connecting pins 4 and 6 for the RTS and pins 7 
and 8 for the CTS, which would use then PE7 for the CTS instead of PE3 
as suggested by the text.

I think this might generate some confusion while reading the documentation.

Regards
José