[En-Nut-Discussion] olimex-sam7-ex256 mmc problem
Andreas Wickström
andreas.wickstroem at spray.se
Mon May 5 20:45:13 CEST 2008
Hi
I did try the same sdcard with another hardware(AT91SAM7XC256-ek from atmel)
and downloaded the latest nutos 4.5.4. And the card worked fine on that
hardware. I tried both the httpd and ftpd. What is the differens between
using the one from atmel and the one from olimex? Has someone got it to work
with the sam7-ex256 card from olimex?
/Andreas
-----Original Message-----
From: en-nut-discussion-bounces at egnite.de
[mailto:en-nut-discussion-bounces at egnite.de] On Behalf Of Ole Reinhardt
Sent: den 4 maj 2008 23:23
To: Ethernut User Chat (English)
Subject: Re: [En-Nut-Discussion] olimex-sam7-ex256 mmc problem
Hi,
> I also wounder is there any way to check if the read partition part is ok?
> I think that my problem lies there some whare. I will investigate that
more
> later in the week.
I've also just seen sd cards formated without any partition at all!
There was used the whole card without any partition table. This kind of
formating won't be supported by NutOS. Could you try to run a fdisk on
this card (perhaps using linux).
Have you had this card in a camera, phone or something similar before?
Btw: What in details does not work? Can't you mount the card or can't
you read / write from / to your card?
Regards,
Ole Reinhardt
--
_____________________________________________________________
| |
| Embedded-IT Hard- und Softwarelösungen |
| |
| Ole Reinhardt Tel. / Fax: +49 (0)271 7420433 |
| Luisenstraße 29 Mobil: +49 (0)177 7420433 |
| 57076 Siegen eMail: ole.reinhardt at embedded-it.de |
| Germany Web: http://www.embedded-it.de |
| UstID / VAT: DE198944716 |
|_____________________________________________________________|
_______________________________________________
http://lists.egnite.de/mailman/listinfo/en-nut-discussion
More information about the En-Nut-Discussion
mailing list