[En-Nut-Discussion] AT91SAM9XE512 conf file

[Ole Reinhardt]

Hi!

> I made a hardware design with the AT91SAM9XE512. 

That's quite interesting. Is this design available anywhere?

> I try to port NUT/OS on it but I am a little confused with the AT91SAM9260
> example.
> May I use the conf. file based on 9260 to start dev on XE512?

Yes, you can use it. It should work without problems.

Btw: I just finished the Linux Board Support Package (BSP) for the
upcomming Ethernut5 platform, which uses the same processor.
Unfortunately egnite has not yet finished the board, but I had the
chance to get one of the very few prototypes.

The BSP consists of the following components:

u-boot (Bootloader, can boot Linux and NutOS)
linux kernel 2.6.28 supporting NAND flash, Dataflash, Ethernet, MMC,
RTC, I2C and SPI interfaces, etc...

Angström Linux distribution, based on OpenEmbedded supporting a full
featured Linux userland.

We'll publish this BSP on our website in a few days including
installation instruction.

Perhaps you are interested in supporting your board as well? In case
you're interested, please contact me in private mail.

Regards,

Ole Reinhardt

-- 
 _____________________________________________________________
|                                                             |
| Embedded-IT          Hard- und Softwarelösungen             |
|                                                             |
| Ole Reinhardt        Tel. / Fax:        +49 (0)271  7420433 |
| Luisenstraße 29      Mobil:             +49 (0)177  7420433 |
| 57076 Siegen         eMail:    ole.reinhardt at embedded-it.de |
| Germany              Web:         http://www.embedded-it.de |
|                      UstID / VAT:       DE198944716         |
|_____________________________________________________________|