[En-Nut-Discussion] Cannot load Ethernut into Olimex sam7-ex256

[Ivan Hamer]

  I managed to get it finally through SAM-BA. (I had to disconnect the OCD programmer, first). I loaded the bin into the flash, and set the gpnvm bit to load from flash. On next reset, it all worked. 
  However, I still haven't figured out how to do the same through OCD. Do I use bin, hex or elf file? What do I specify as start address (if anything)? I have tried few combinations, but still can't get it to run... 

--- On Sun, 2/22/09, Ole Reinhardt <ole.reinhardt at embedded-it.de> wrote:

> From: Ole Reinhardt <ole.reinhardt at embedded-it.de>
> Subject: Re: [En-Nut-Discussion] Cannot load Ethernut into Olimex sam7-ex256
> To: ticica at gmail.com, "Ethernut User Chat (English)" <en-nut-discussion at egnite.de>
> Date: Sunday, February 22, 2009, 8:24 AM
> Hello,
> 
> >   I have tried SAM-PROG v2.4, but the flash button is
> always grayed out (even though SAM-BA v2.8 manages to
> connect).
> 
> Are you shure you first have set the erase jumper and
> resettet your
> board before trying to reprogram your board with sam-ba?
> 
> I'm programming my board mostly using OpenOCD to
> program the flash via
> jtag and I never had any problems.
> 
> Bye
> 
> Ole Reinhardt
> 
> -- 
> 
> _____________________________________________________________
> |                                                          
>   |
> | Embedded-IT          Hard- und Softwarelösungen         
>    |
> |                                                          
>   |
> | Ole Reinhardt        Tel. / Fax:        +49 (0)271 
> 7420433 |
> | Luisenstraße 29      Mobil:             +49 (0)177 
> 7420433 |
> | 57076 Siegen         eMail:   
> ole.reinhardt at embedded-it.de |
> | Germany              Web:        
> http://www.embedded-it.de |
> |                      UstID / VAT:       DE198944716      
>   |
> |_____________________________________________________________|
> 
> _______________________________________________
> http://lists.egnite.de/mailman/listinfo/en-nut-discussion