[En-Nut-Discussion] Problem with Ethernut-Board: Pin 3 on PortB

[Ole Reinhardt]

Hi!

> I have a problem with pin 3 at PortB. Whenever i set pin 3 and pin 4 to high, 
> voltage on pin3 drops to ca 1 volts. when pin4 is not set to high, everything is fine. 

This sounds quite strange. Can you give me some ascii art of your
external wiring?

Are these boards from egnite or are they self build?

Your code looks fine, there should'nt be any problem.

Regards,

Ole

-- 
 _____________________________________________________________
|                                                             |
| Embedded-IT                                                 |
|                                                             |
| Ole Reinhardt        Tel. / Fax:        +49 (0)271  7420433 |
| Luisenstraße 29      Mobil:             +49 (0)177  7420433 |
| 57076 Siegen         eMail:    ole.reinhardt at embedded-it.de |
| Germany              Web:         http://www.embedded-it.de |
|_____________________________________________________________|