[En-Nut-Discussion] Ethernut 3.0 limits

[Javier Longares]

Hi Ole,

Thank you for your response. I've tried it but it doesn't work.  I've
discovered in our shelves that we bought an AVRATJTAGICE, may be it can help
me.  Anyway, we have bought 5 or 6 boards to egnite and then we could try
the Alastairs instructions stated in the FAQ.

Of course, if you have some idea, it will be welcome.

Best regards.

2010/1/29 Ole Reinhardt <ole.reinhardt at embedded-it.de>

> Hi!
>
> > > halt
> > target state: halted
> > target halted in Thumb state due to debug-request, current mode:
> Supervisor
> > cpsr: 0x400000f3 pc: 0xffffffc2
> > > flash probe 0
> > memory write caused data abort (address: 0x10000aaa, size: 0x2, count:
> 0x1)
> > unknown error when probing flash bank '#0' at 0x10000000
>
> I know this behaviour. The problem is, that the CPU get's stuck in a
> abort exception right at the beginning of the flash.
>
> You need to halt the CPU as early as possible.
>
> Try
>
> reset halt
> flash probe 0
> flash erase_sector 0 0 15
> flash write_bank 0 my_file.bin 0
>
> reset
>
> Hope this helps..
>
> Bye,
>
> Ole
>
> --
>
> Thermotemp GmbH, Embedded-IT
>
> Embedded Hard-/ Software and Open Source Development,
> Integration and Consulting
>
> Geschäftsstelle Siegen - Steinstraße 67 - D-57072 Siegen -
> tel +49 (0)271 5513597, +49 (0)271-73681 - fax +49 (0)271 736 97
>
> Hauptsitz - Hademarscher Weg 7 - 13503 Berlin
> Tel +49 (0)30 4315205 - Fax +49 (0)30 43665002
> Geschäftsführer: Jörg Friedrichs, Ole Reinhardt
> Handelsregister Berlin Charlottenburg HRB 45978 UstID DE 156329280
>
> _______________________________________________
> http://lists.egnite.de/mailman/listinfo/en-nut-discussion
>