[En-Nut-Discussion] Ethernut 1.3 Rev C

[Greco, John F]

Harald-
Thanks very much for posting the information for the 1.3C. We are using the newer 1.3H boards but we had received the 1.3C (incorrectly) from a vendor. Perhaps we will find a use for the older board.

We use the 1.3H boards for controlling a rapid transit system that we constructed using model railroad components. Five boards are used, and each board is responsible for a section of the system. The boards communicate with each other via Ethernet, and they also serve web pages to allow user input of system parameters. The system is used in a senior elective course in our Electrical and Computer Engineering Department here at Lafayette College. (I plan to describe the project on the Ethernut project site.)

I really must thank you for developing this product. It has been a valuable addition to our program, and the students have enjoyed getting the system to work while learning about programming real-time control software.

All the best,
John

----- Original Message -----
From: "Harald Kipp" <harald.kipp at egnite.de>
To: en-nut-discussion at egnite.de
Sent: Sunday, January 23, 2011 5:49:58 AM
Subject: Re: [En-Nut-Discussion] Ethernut 1.3 Rev C

Hi John,

On 1/22/2011 12:18 AM, Greco, John F wrote:
> Does anyone have a schematic diagram for Ethernut 1.3 Rev C? Or any other reference material for the board. I have a board, but no documentation.

Wow, nearly 10 years ago.

I've appended schematics and layout at

http://www.ethernut.de/en/hardware/enut1/

The Rev-F manual should still be valid for your hardware.

Regards,

Harald
_______________________________________________
http://lists.egnite.de/mailman/listinfo/en-nut-discussion