[En-Nut-Discussion] Ethernut 1.3H problem with Ethernet and external RAM

[Ayman Hendawy]

Dears,

Recently I replaced the ATMEL128 with new one, but I get a problem that the
Basemon bootloader can't see my Ethernet chip nor External RAM, the out on
serial port as following:

BaseMon 4.1.2
Nut/OS 3.5.0.0
Compiled by AVRGCC for ATmega128
Baudrate select = 95
External RAM Test... 0 bytes
Banked RAM Test...   none
Serial FLASH...      0 bytes
Detecting NIC...     none
I/O Port Test...     OK

Press any of the following keys:
    E - Ethernet controller read/write
    J - Jump to bootloader
    S - SRAM read/write


The Yellow led is off, and Green led is sold on.

The fuses are as following:
lfuse: 0x3f
hfuse: 0x82
eFuse:0xff

When I used the test code at
http://www.ethernut.de/en/hardware/enut1/index.html ,
www.ethernut.de/en/hardware/enut1/testrtl10.zip
I get the following:

101 RTL8019AS Test 1.0
104 Discovered
100 Write OK
100 Config OK
102 EEPROM emulation OK
101 Re-discovered
101 Stopped
101 Reset OK
100 Memory OK
121 Loopback 1 OK
122 Loopback 2 OK
123 Loopback 3 OK
130 IRQ OK
499 NIC OK
100 Ready for ping 192.168.192.254 (MAC 00:06:98:F0:11:23)
100 Rx[0x21]: OK PHY
100 No ARP request
100 Not ICMP
100 Rx[0x21]: OK PHY
100 No ARP request
100 Not ICMP
100 Rx[0x21]: OK PHY
100 No ARP request
100 Not ICMP
100 Rx[0xA1]: OK PHY DFR
100 No ARP request
100 Not ICMP
100 Rx[0x21]: OK PHY
100 No ARP request
100 Not ICMP


But I can't ping it !

I don't know what is the problem, any suggestions


Thanks


-- 
Best regards

Ayman Hendawy
Embedded system engineer