[En-Nut-Discussion] compiling for CM3

[Uwe Bonnes]

>>>>> "Klaus" == Klaus Kloos <klaus.kloos at gmx.de> writes:

    Klaus> Hello I have problems compiling the apps from a ethernut 5.1
    Klaus> using cm3-gcc or cm3-gccdbg with stm3210c-eval.conf. My gcc is
    Klaus> 4.6.0 The linker does not find the NutOS-functions. Building
    Klaus> nutos itself using qnutconf.exe does not bring up any error.
    Klaus> While searching for the dependencies in the makefiles, makedefs
    Klaus> and makevars ive got lost.  What am I doing wrong?

    Klaus> Two small feedbacks from the view of a non experienced nutos
    Klaus> user.  -nutconf.exe does not start. lua51.dll was not
    Klaus> found. qnutconf.exe is working.  -in qnutconf.exe the default
    Klaus> path for choosing a conf file is taken from a previously used
    Klaus> older version. So the wrong conf folder is shown and windows does
    Klaus> not show the path to see this fault fast. For me it seems better
    Klaus> to save the default-path related to the ethernut version.

Did you _active_ accept the needed licenses? For STM32 you need to accept
the MCD_STLIBERTY and ST_GUIDANCE_ONLY licenses. This results in the lines
LICENSE_MCD_ST_LIBERTY = ""
LICENSE_ST_GUIDANCE_ONLY = ""
added to the conf file.

Bye
-- 
Uwe Bonnes                bon at elektron.ikp.physik.tu-darmstadt.de

Institut fuer Kernphysik  Schlossgartenstrasse 9  64289 Darmstadt
--------- Tel. 06151 162516 -------- Fax. 06151 164321 ----------