[En-Nut-Discussion] FW: Ethernut 1.3 Rev-H dead?

[Harald Kipp]

Hi Nedim,

On 13.03.2013 16:19, Nedim Z wrote:

> After pressing the reset button on my Ethernut 1.3 (Rev-H) while having a a crossover ethernet cable, a JTAGICE MKII (turned on) and a serial cable to the RS232 connected, the device seemed to stop working. Now, it does not power on. I was in Tera Term, trying to get BaseMon running. I had not flashed or programmed anything on the ATMEGA 128 yet, meaning that the setup was factory settings.

May be a short cut somewhere? For protection, Ethernuts are equipped
with a very sensitive fuse.

Remove all external hardware and replace the fuse. egnite ships all
boards with a spare one. If no longer available, here's the part#

Littelfuse 0453 001, 1A fast

Hope this helps,

Harald