[En-Nut-Discussion] Problem with http web server

[Dan Pat]

Hi, Harald
 
I just down load avr Studio and check the Fuses
the check box with mark on the fuse
1.Serial program downloading(SPI)enable,[spien=0]
2.boot flash section size=512 words bootstart address=$fe00;[bootsz=11]
3.brown out detection level at vcc=2.7v;[bodlevel=1]
4.ext, cryatal/resonator high fre; start-up time:16k ck+64ms;[cksel=1111svt=11]
 
This four box checked mark and in bottam it is give message that
Deteccting faileld:
 
Also in Signature bytes
it,s say's
signature not read
 
Detecting failed.
 
Hope This help you to find problem.
Wait for your answer. thanks you very much for your help.
Dan

Harald Kipp <harald.kipp at egnite.de> wrote:
You'll find it on the second page of the STK500 dialog
in AVR Studio.

Can you please tell me, which boxes are checked?
Also look to the messages on the bottom of the
fuses page. You may also try reading the signature
bytes (Click on the "Advanced" tab).

Also have a look to
http://www.ethernut.de/en/faq.html Part 3

Regards,
Harald

Just in case: Please do not post any screen dumps to
the list. They would spoil the archive and not all
subscribers like that much traffic.

_______________________________________________
En-Nut-Discussion mailing list
En-Nut-Discussion at egnite.de
http://www.egnite.de/mailman/listinfo.cgi/en-nut-discussion

---------------------------------
Do you Yahoo!?
New Yahoo! Photos - easier uploading and sharing
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.egnite.de/pipermail/en-nut-discussion/attachments/20031218/e918111e/attachment.html>