[En-Nut-Discussion] 10M ethernet problems?

[Lars Andersson]

Hi Danny,
 
The Ethernut board will only work on a 10Mbit network. The way to solve the problem is what you have done, adding a switch in between thenetwork and your Ethernut . A switch will usually detect that the Ethernut card operates at 10Mbit and therefore sets the network speed to this.
 
/Lars

-----Original Message-----
From: danny-cvs [mailto:danny at acronexus.com]
Sent: den 13 mars 2003 02:22
To: en-nut-discussion at egnite.de
Subject: [En-Nut-Discussion] 10M ethernet problems?



I connect my ethernut to a 10/100 hub and try to do some serial-to-ethernet communications, but I found the ethernut will be unstable and sometimes disconnection when it is in a 10/100M ethernet topology. However, when I use a 10/100 switch-hub it work very well! I want to ask: if the RTL8019AS cannot race 10/100M ethernet controller? or there is any method to enhance the connection stability?
 
Best Regard
Danny Lu 


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.egnite.de/pipermail/en-nut-discussion/attachments/20030313/16761a76/attachment-0001.html>