[En-Nut-Discussion] Ethernet interface not properly booting

[Lars Andersson]

Maybe you should look at DS1813 to replace DS1811?
It debounces the reset push button. I do not have
the schematic of version F but I belive it will
work on your board w/o modification.

Lars H. Andersson

(Lots of Lars Anderssons on this group so I 
 put a middle initial in)

-----Original Message-----
From: en-nut-discussion-admin at egnite.de
[mailto:en-nut-discussion-admin at egnite.de] On Behalf Of Harald Kipp
Sent: Wednesday, 10 September, 2003 18:36
To: en-nut-discussion at egnite.de
Subject: Re: [En-Nut-Discussion] Ethernet interface not properly booting


Michel,

The opposite case is well known. Power on will fail, if the DS1811
is broken, because the Realtek needs a hardware reset signal.

May be the reset switch weared out, producing a bad signal. We
replaced the previous Omron through hole reset switch with the
Schurter SMD part. Hopefully that wasn't a bad decision. Just
today I talked to another user on the phone, who experienced a
similar problem. But it fortunately disappeared as sudden as
it appeared. He critisized, that there's no RC delay mounted
at the reset switch to avoid switching noise and I replied, that
there were no problems with it so far...grumble...

Anyone else around here with reset switch problems and Rev. 1.3F?

Harald

_______________________________________________
En-Nut-Discussion mailing list
En-Nut-Discussion at egnite.de
http://www.egnite.de/mailman/listinfo/en-nut-discussion