[En-Nut-Discussion] IDE interface

[Kyle Rhodes]

Has anyone looked into the Atmel AVR IDE board that http://www.edtp.com
sells?  I suggest downloading the archive for the board and looking at
the code.  I believe it supports "AVR DOS", so I assume at least FAT16
is implemented.  I also read something about CF support.


Kyle Rhodes
Hardware / Software Engineer
gh, LLC
3000 Kent Ave
Lafayette, IN 47906
(765) 775-3776  ext 205


-----Original Message-----
From: Richard Sloan [mailto:rsloan2003 at hotmail.com] 
Sent: Thursday, February 12, 2004 3:30 PM
To: en-nut-discussion at egnite.de
Subject: RE: [En-Nut-Discussion] IDE interface

Thanks!

What is status on FAT16/32 writes?

Richard.


>From: fischermi at t-online.de (Michael Fischer)
>Reply-To: "Ethernut User Chat (English)" <en-nut-discussion at egnite.de>
>To: <en-nut-discussion at egnite.de>
>Subject: [En-Nut-Discussion] IDE interface
>Date: Thu, 12 Feb 2004 21:04:37 +0100
>
>Richard,
>
>I think it could be a good idee,
>that you can check our interface?
>
>Are you familiar with the programming too?
>I have the problem if I connect 2 IDE devices like a hard disk and a cd

>rom,
>or two disk. The software supports now:
>
>- hard disk
>- cd rom
>- zip drive (100MB)
>- cf cards
>
>But in the moment only the read functionality.
>
>Michael
>
>
>_______________________________________________
>En-Nut-Discussion mailing list
>En-Nut-Discussion at egnite.de
>http://www.egnite.de/mailman/listinfo.cgi/en-nut-discussion

_________________________________________________________________
The new MSN 8: advanced junk mail protection and 2 months FREE*  
http://join.msn.com/?page=dept/bcomm&pgmarket=en-ca&RU=http%3a%2f%2fjoin
.msn.com%2f%3fpage%3dmisc%2fspecialoffers%26pgmarket%3den-ca

_______________________________________________
En-Nut-Discussion mailing list
En-Nut-Discussion at egnite.de
http://www.egnite.de/mailman/listinfo.cgi/en-nut-discussion