[En-Nut-Discussion] Odd Programming Issue

[Kyle Klosinski]

I'm using the command line stk500.exe to program the ethernut with an
ISP dongle. I had programmed portdio.hex (the one included with the
Nut/OS download) into the ethernut and was accessing it over telnet,
when all of a sudden it stopped responding. I went to reset it using
the little button on the board, and it didn't seem to do anything. The
lights never flickered, but the Link and Pwr lights stayed on. I then
tried unplugging it and replugging it in, to no avail. Ever since this
happened, when I try to program anything into it or simply erase it,
the memory stays the same, just the odd looking hex file (see link below), no
change no matter what I try to program in. I use the following line to
program it (stk500 -dATMEGA128 -if<file>.hex -e -pf -vf) and it has
worked in the past.

Thanks in advance.
Kyle Klosinski

Hex file: http://yoda634.com/output.hex -- right click, save as.