[En-Nut-Discussion] Question about purchasing the Ethernet Controller chip

[neti krishna pavan]

An HTML attachment was scrubbed...
URL: <http://lists.egnite.de/pipermail/en-nut-discussion/attachments/20040507/78269f51/attachment-0001.html>
-------------- next part --------------
   
Hai Leo 
  
           Iam Krishna pavan....Regarding the RTL8019AS chip i have 
one suggestion for you.....Will it not be a good idea if you can try 
out for an ethernet card(the ISA bus compatible card---with RTL8019AS 
being on board) and try to interface that with your TI development 
board....that may also eliminate your problems with soldering the 
pins of the chip on to the board too....i think u can try out for 
that card in old PC's since new ones are using PCI slots.... 
          Ok,and  by the way may i know your personal details as to 
where u are from and your university......... 
See U then 
Best wishes 
Krishna Pavan 
Pune 
On Thu, 06 May 2004 leo at dsp.ee.itb.ac.id wrote : 
>Hi all! 
> 
>I have some difficulties in purchasing the Ethernet Controller chip 
>RTL8019AS.. I need it for my final project in my undergraduate 
program.. 
>My final project is about developing an interface board between the 
TI 
>(Texas Instrumets) TMS320C54X development board and the ethernet 
network 
>using RJ45 cable.. 
>I have tried to contact Realtek Co. in Siangpore, but they said that 
the 
>minimum amount of purchase is about 60 pieces.. 
>i don,t need that much, i only need maybe about 3 chips.. 
>so could anyone who knows about it tell me how to have the RTL8019AS 
chips? 
> 
>regards, 
> 
>Leo Hendrawan 
> 
>_______________________________________________ 
>En-Nut-Discussion mailing list 
>En-Nut-Discussion at egnite.de 
>http://www.egnite.de/mailman/listinfo.cgi/en-nut-discussion