[En-Nut-Discussion] New user and having to press reset for the NIC

[Scott m Goeken]

Sorry if this is a duplicated post I sent in one yesterday and it does not 
look like it worked.

I recently bought a Ethernet 2 board and have no problem uploading the 
programs to the board but when I try to run any of them they only recognize 
the ethernet NIC after I press reset. 

Here is the output from the BaseMon program after just plugging in the power 
supply. Note is does not find the NIC.


BaseMon 4.0.2
Nut/OS 3.4.2.1
Compiled by AVRGCC for ATmega128
Baudrate select = 23
External RAM Test... 44800 bytes
Banked RAM Test...   30 banks, 16384 bytes ea.
Detecting NIC...     none
I/O Port Test...     OK

Press any of the following keys:
    B - Send broadcasts
    E - Ethernet controller read/write
    J - Jump to bootloader
    S - SRAM read/write


Here is the output when press reset. Note it finds the NIC this time
BaseMon 4.0.2
Nut/OS 3.4.2.1
Compiled by AVRGCC for ATmega128
Baudrate select = 23
External RAM Test... 44800 bytes
Banked RAM Test...   30 banks, 16384 bytes ea.
Detecting NIC...     LAN91C111
Testing NIC...       OK
I/O Port Test...     OK

Press any of the following keys:
    B - Send broadcasts
    E - Ethernet controller read/write
    J - Jump to bootloader
    S - SRAM read/write
    X - Exit BaseMon, configure network and start WebServer


The board works the same no matter what program I try to run on it, only sees 
the NIC after a reset. Is this normal or am I doing something wrong.


Thanks
Scott