[En-Nut-Discussion] programming with stk500

[Sebastian Schucht]

Hallo,

I use the stk500 board to programm the ethernut 1.3 over the 10 Pin ISP-Port. 
I have mount the jumper near the ISP port and running uisp on linux. 

uisp -dprog=stk500 -dserial=/dev/ttyS0 -dspeed=115200 -dpart=atmega128 --erase 
--upload if=httpserv.hex
Firmware Version: 1.15
Failed to enter programming mode.
make: *** [burn] Fehler 2

if i press the reset button on the ethernut during the programming process the 
run looks fine but if i reset the bord the old appliaction starts.

thanks for your help

Sebastian Schucht