[En-Nut-Discussion] Ethernut UART0 question.

[Harald Kipp]

No, RTS/CTS is not required. Probably an oscilloscope will
help to track down your problem.

Harald

At 10:20 22.04.2005 +0200, you wrote:
>Dear Developers,
>
>     I use ethernut in a abosolutly homemade board, and project. I
>tried to use the uart0 device, but is not worked. I found the
>schematics of your ethernut 1.3 project, and I saw that you use RTS/ CTS 
>wires too. I wired only RX and TX from processor to the serial
>port (through maxim's serial voltage converter).
>     Can I use the uart0 device in 3 wire mode, or I must wire RTS/ CTS too.
>
>Yours,
>     Tamas Virag