[En-Nut-Discussion] Ethernut UART0 question.

[Tamas Virag]

Dear Developers,

     I use ethernut in a abosolutly homemade board, and project. I  
tried to use the uart0 device, but is not worked. I found the  
schematics of your ethernut 1.3 project, and I saw that you use RTS/ 
CTS wires too. I wired only RX and TX from processor to the serial  
port (through maxim's serial voltage converter).
     Can I use the uart0 device in 3 wire mode, or I must wire RTS/ 
CTS too.

Yours,
     Tamas Virag