[En-Nut-Discussion] Unable to burn sample basemon.hex file to the new Ethernut 2.1b

[Andrej Fronc]

Hi,
I tried to programm the sample basemon.hex into the ethernut 2.1b from 
the starter kit, but the process allways freeze:

D:\data\dgs\ethernut\nutapp-21b\basemon>make burn
uisp -dprog=stk500 -dserial=/dev/ttyS1 -dspeed=115200 -dpart=atmega128 
--erase -
-upload if=basemon.hex
Firmware Version: 49.50
Atmel AVR ATmega128 is found.
Uploading: flash

At the begining chages the led on the programming adapter green and red, 
but after one or two seconds it changes to green and do nothing.

I'm using the jtag connector.

D:\data\dgs\ethernut\nutapp-21b\basemon>uisp -dprog=stk500 -dserial=com2 
-dspeed
=115200 -dpart=atmega128 --rd_fuses
Firmware Version: 49.50
Atmel AVR ATmega128 is found.

Fuse Low Byte      = 0x3f
Fuse High Byte     = 0x83
Fuse Extended Byte = 0xff
Calibration Byte   = 0x00  --  Read Only
Lock Bits          = 0xc0
    BLB12 -> 0
    BLB11 -> 0
    BLB02 -> 0
    BLB01 -> 0
      LB2 -> 0
      LB1 -> 0

I'm beginer in Ethernut Thema. Do anybody have any idea whats wrong?

mgf
Andrej Fronc