[En-Nut-Discussion] Ethernut 2.1 UART0 and UART1 "access"

[Harald Kipp]

Hello Ernst,

The picture near the end of
http://www.ethernut.de/en/nuttecnotes/ntn-1_ppp.html
may help too.

Harald

At 20:26 27.06.2005 +0200, you wrote:
>Hello All!
>
>I need to connect to both UART0 and UART1 on an Ethernut 2.1 board. And in
>addition, I need +12V and - 12V (or better one RS2323 high and one RS232 low
>signal on the UART1 connector.
>
>Has anybody run across this (or a similar) requirement and found an
>easy/simple/inexpensive solution regarding:
>
>how to connect to the board,
>which cables (ribbon or else) to use,
>if a custom mini PCB for mounting the 2 x DSUB-9 and wiring makes sense,
>and the like.
>
>Any suggestions / opinions welcome
>
>Thanks & Regards
>Ernst