[En-Nut-Discussion] bootloader (newbie)

[Klemen Dovrtel]

I was reading the bootloader section on
www.ethernut.de. It says that i should upload the boot
loader hex file to the Ethernut board using an ISP
adapter - isn't that already done? How can i programm
the uC if the isp pins are not connected to isp
connector.
Then i used the TFTPD32 and set it like it says. When
i try to programm the uC, this is all i get (and
nothing happens:
Rcvd DHCP Rqst Msg for IP 0.0.0.0, Mac
00:06:98:01:08:71 [23/11 20:42:44.265]
Rcvd DHCP Rqst Msg for IP 0.0.0.0, Mac
00:06:98:01:08:71 [23/11 20:42:52.265]
Rcvd DHCP Discover Msg for IP 0.0.0.0, Mac
00:06:98:01:08:71 [23/11 20:43:08.265]
DHCP: proposed address 192.168.0.87 [23/11
20:43:08.265]
Rcvd DHCP Rqst Msg for IP 0.0.0.0, Mac
00:06:98:01:08:71 [23/11 20:43:12.265]
Previously allocated address acked [23/11
20:43:12.281]

What is wrong? 

Best regards,
Klemen

  


		
__________________________________ 
Yahoo! FareChase: Search multiple travel sites in one click.
http://farechase.yahoo.com