[En-Nut-Discussion] how to program the ethernut

[Klemen Dovrtel]

uC=microcontroller
Ponyprog is ok, i can program atmega8.
Would you please send me the scheme of programmer you
use.
Best regards 

--- Thiago A. Corrêa <thiago.correa at gmail.com> wrote:

> I don't know what is uC, but a locked processor does
> read "something"
> in the ponyprog, it reads some garbage data, but
> doesn't give you
> "device not found". I do know that it is a bit hard
> to setup pony, it
> had issues with many pcs where I work... something
> with the LPT that I
> can't quite figure out. One thing I always do is set
> it to ECC+EPP in
> the bios, seams to work sometimes. Also, my working
> machine has the
> LPT1 in 0x378, that info might be helpfull.
> 
> I don't have the scheme for the programmer I'm using
> right now, but I
> can send you a link on monday if you want, we built
> ours with some
> spare parts, not hard to assemble :)
> 
> On 11/25/05, Klemen Dovrtel
> <klemen_dovrtel at yahoo.com> wrote:
> > I connected the vcc, gnd, miso, mosi, sck and rst
> (i
> > removed r22 and added r34) to my ponyprog
> programmer
> > and try to read data from uC, but i get an error
> > (device missing). I am shure that the connsetions
> are
> > ok, and the programmer is ok. The ethernut board
> is
> > new. Why is that? Is the uC locked?
> >
> >
> >
> > __________________________________
> > Yahoo! Music Unlimited
> > Access over 1 million songs. Try it free.
> > http://music.yahoo.com/unlimited/
> > _______________________________________________
> > En-Nut-Discussion mailing list
> > En-Nut-Discussion at egnite.de
> >
>
http://www.egnite.de/mailman/listinfo.cgi/en-nut-discussion
> >
> _______________________________________________
> En-Nut-Discussion mailing list
> En-Nut-Discussion at egnite.de
>
http://www.egnite.de/mailman/listinfo.cgi/en-nut-discussion
> 



	
		
__________________________________ 
Yahoo! Mail - PC Magazine Editors' Choice 2005 
http://mail.yahoo.com