[En-Nut-Discussion] CAN sniffing program?

[Alexander Baranov]

Hi, All.
We are trying to implement atmega90CAN128. Could anybody advise a program
(preferably with source ) that would sniff CAN-bus transactions and send
data to e.g. RS232 port?  Or advise why this my desire may be unreasonable?
Regards, Alexander.

----- Original Message ----- 
From: "Bernard Fouché" <bernard.fouche at kuantic.com>
To: "Ethernut User Chat (English)" <en-nut-discussion at egnite.de>
Sent: Tuesday, September 20, 2005 8:48 AM
Subject: [En-Nut-Discussion] NutLoadConfig/NutNetConfig/NutDhcpIfConfig


> Hi.
>
> I'm getting lost between all these functions. Basically I want an
> Ethernut to be setup correctly once with basemon then I want to flash my
> own application (made from httpserv.c) and have it getting back all
> parameters previously set with the 'X' command of basemon. I'm using
> ethernut-3.9.8.
>
> So:
>
> 1) I flash my  ethernut with basemon. I use 'X' to set all network
> parameters. It works. (I use 10.0.0.02 ip address)
> 2) I press the reset button, retype 'X' and see that my previous
> parameters are still there.
> 3)  I flash httpserv.hex. It calls NutDhcpIfConfig() but starts by using
> 192.168.192.100 as ip address.
>
> What I want:
>
> - perform step 1 & 2.
> - what function my application must call to correctly retreive what was
> set in step one and, if the EEPROM data is bad, then only use dhcp to
> recover an address?
>
> Also some piece on documentation on that topic in the doxygen output
> would be nice!
>
> Thanks!
>
>   Bernard
> _______________________________________________
> En-Nut-Discussion mailing list
> En-Nut-Discussion at egnite.de
> http://www.egnite.de/mailman/listinfo.cgi/en-nut-discussion
>
>