[En-Nut-Discussion] CAN sniffing program?

[Alexander Baranov]

Ole and Uwe, thanks a lot. If the idea does not fade I will use your
advises.
----- Original Message ----- 
From: "Uwe Bonnes" <bon at elektron.ikp.physik.tu-darmstadt.de>
To: "Ethernut User Chat (English)" <en-nut-discussion at egnite.de>
Sent: Wednesday, September 21, 2005 12:03 PM
Subject: Re: [En-Nut-Discussion] CAN sniffing program?


> >>>>> "Ole" == Ole Reinhardt <ole.reinhardt at kernelconcepts.de> writes:
>
>     Ole> Hi Alexander,
>     >> We are trying to implement atmega90CAN128. Could anybody advise a
>     >> program (preferably with source ) that would sniff CAN-bus
>     >> transactions and send data to e.g. RS232 port?  Or advise why this
my
>     >> desire may be unreasonable?
>
>     Ole> I could offer you one of our M-CAN Boards. These Boards run
>     Ole> NutOS. They are using the SJA1000 Controller as CAN controller.
It
>     Ole> is a easy task to log the can traffic and send it over a serial
>     Ole> interface. There is only one limitation. CAN 2.0b can use up to 1
>     Ole> MBit Bitrates. Of course an RS232 Interface can not, so you have
to
>     Ole> user lowe CAN Bitrates.
>
> The CAN200 parallelport adapter with the CANBUS4LINUX driver and the
> acceptance filter set to "ffffffff ffffffff" should do the job too.
>
> Bye
> -- 
> Uwe Bonnes                bon at elektron.ikp.physik.tu-darmstadt.de
>
> Institut fuer Kernphysik  Schlossgartenstrasse 9  64289 Darmstadt
> --------- Tel. 06151 162516 -------- Fax. 06151 164321 ----------
> _______________________________________________
> En-Nut-Discussion mailing list
> En-Nut-Discussion at egnite.de
> http://www.egnite.de/mailman/listinfo.cgi/en-nut-discussion
>
>