[En-Nut-Discussion] Problem with source board layout

[riv at asvt.ru]

 From Eagle files ethernut. registred version of eagle , 
i'm view only 2-layer board. :(



On Tue, 14 Feb 2006 10:19:51 +0100
  Harald Kipp <harald.kipp at egnite.de> wrote:
>At 21:44 12.02.2006 +0300, you wrote:
>>Good afternoon,
>>I collect a breadboard model of the device ethernut 1.3 
>>rev G from eagle files. etc..
>>
>>I have found that on the scheme is not present layout VCC 
>>(eagle format)
>>
>>I'm very much to look photos of the original 1.3G from a 
>>bottom side, please to any friends - send me photo.
>>
>>Also I had a question, in an original breadboard model 
>>are used two-layer or three-layer layout?
>
>I do not have any photo available from the backside and 
>IMHO
>it is not required. Please take a look to the Eagle board
>files at
>http://www.ethernut.de/en/download/index.html
>
>All Ethernut PCBs are 4 layer with ground and Vcc
>in the two inner layers.
>
>Hope this answered your questions,
>
>Harald
>
>_______________________________________________
>En-Nut-Discussion mailing list
>En-Nut-Discussion at egnite.de
>http://www.egnite.de/mailman/listinfo.cgi/en-nut-discussion