[En-Nut-Discussion] Problem with source board layout

[John Lin]

I had the same mistake before... then I found you have to unhide those other
layers, so you can see all layers...


On 2/14/06, riv at asvt.ru <riv at asvt.ru> wrote:
>
> From Eagle files ethernut. registred version of eagle ,
> i'm view only 2-layer board. :(
>
>
>
> On Tue, 14 Feb 2006 10:19:51 +0100
>   Harald Kipp <harald.kipp at egnite.de> wrote:
> >At 21:44 12.02.2006 +0300, you wrote:
> >>Good afternoon,
> >>I collect a breadboard model of the device ethernut 1.3
> >>rev G from eagle files. etc..
> >>
> >>I have found that on the scheme is not present layout VCC
> >>(eagle format)
> >>
> >>I'm very much to look photos of the original 1.3G from a
> >>bottom side, please to any friends - send me photo.
> >>
> >>Also I had a question, in an original breadboard model
> >>are used two-layer or three-layer layout?
> >
> >I do not have any photo available from the backside and
> >IMHO
> >it is not required. Please take a look to the Eagle board
> >files at
> >http://www.ethernut.de/en/download/index.html
> >
> >All Ethernut PCBs are 4 layer with ground and Vcc
> >in the two inner layers.
> >
> >Hope this answered your questions,
> >
> >Harald
> >
> >_______________________________________________
> >En-Nut-Discussion mailing list
> >En-Nut-Discussion at egnite.de
> >http://www.egnite.de/mailman/listinfo.cgi/en-nut-discussion
>
> _______________________________________________
> En-Nut-Discussion mailing list
> En-Nut-Discussion at egnite.de
> http://www.egnite.de/mailman/listinfo.cgi/en-nut-discussion
>