[En-Nut-Discussion] Ethernut 3.0 no Program runs

[Thorsten Schöffel]

Hello,

i have some troubles to make a program run on the ethernut 3.0.
I use the bootmon to load the httpserv.bin which i have compiled with
my ip and mac address. After make install it is in the folder bin/arm7tdmi .
I can see that the ethernut is downloading from tftp.
After that nothing happens and after a reset the bootmon is back.

So i tried to use the jtag.
make burn works, but after a reset nothing happens in the terminal.
It stays empty.
After that i reinstalled the bootmon. Here the make burn works too and
i can use the bootmon again in the terminal.

Has someone a solution how i can get a program to run?

Best regards

Thorsten