[En-Nut-Discussion] Ethernut 5.0 Schematic Preview

[duane ellis]

Ole Reinhardt wrote:
> - CMOS Image Sensor Interface
>   
>
> I can't see any I2C interface connected to the camara connector. Am I
> right? I2C and perhaps SPI could be _very_ usefull as some camera
> sensors will be configured using these interfaces.
>
>   
I too agree about the i2c - ie: Micron (now known as aptina) sensors use 
i2c to configure them.
And - for example cypress uses SPI on some of their sensors.

Alternate would be an additional jumper - or solder pads (zero-ohm) some 
where to hook up.

-Duane.