[En-Nut-Discussion] Could not enter programming mode

[Matthias Ringwald]

isn't there an stk500v2 or avrispv2? try these.

matthias

On Sep 25, 2009, at 6:15 PM, Daniel wrote:

> Hi Harald,
>
> Harald Kipp schrieb:
>> Btw. stk500.exe is probably OK and a good choice with ICCAVR. If not
>> using ImageCraft, I'd consider using avrdude. It is much better
>> supported and works very well.
>>
> I tried to use avrdude but when I choose "stk500" as programmer type,
> then I get the apparently well-know error "not in sync: resp=0x00".  
> The
> programmer shows SW Version 2.3. When I use choose "avr910" as
> programmer type, then there is no sync error, but avrdude exits,  
> because
> "the ATMega 128 is not supported". Which programmer type should I use?
>
> By the way, on the page "http://www.ethernut.de/de/isp/spduo.html" the
> files for spduo22.enc and spduo23.enc are not correctly linked I  
> think.
>
>
> Daniel
> _______________________________________________
> http://lists.egnite.de/mailman/listinfo/en-nut-discussion