[En-Nut-Discussion] Phy initialisation on at91 platform

[Ulrich Prinz]

Hi!

The AT91SAM7X-EK needs this init too, so the special board init should
be enabled for it too in the conf file.

Ulrich

Am 23.05.2011 11:53, schrieb Ole Reinhardt:
> Hi all,
> 
> For most at91 based boards Harald implemented a special board
> initialisation in arch/arm/board where the Ethernet PHY will be resetted
> with the boot strap pins set correctly.
> 
> in arch/arm/dev/at91_emac.c there is still on special initialisation
> case left for Davicom PHYs. I would like to move this PHY reset to the
> board init as well bot do not want to brake any existing code there...
> 
> So is any board depending on this special case in EmacReset() beside of
> our eNet-sam7X board?
> 
> If no one complains I would create a board init for our board today and
> will remove this reset code in at91_emac.c.
> 
> Bye,
> 
> Ole
> 
>