[En-Nut-Discussion] Compiling toolchain and programs on Windows

[Philipp Burch]

Hi Uwe!

On 11/25/2013 05:36 PM, bon at elektron.ikp.physik.tu-darmstadt.de wrote:
>>>>>> "Philipp" == Philipp Burch <phip at hb9etc.ch> writes:
>
>      Philipp> Hi everyone, the project I've been working on for quite a while
>      Philipp> now has reached a state in which I should get the development
>      Philipp> environment on our company computers. Unlike my notebook, those
>      Philipp> all boot Windows, so I'm facing the (usual)
>      Philipp> Linux-to-Windows-hassles.
>
>      Philipp> Using Cygwin, I've now managed to compile the Ethernut tools
>      Philipp> itself (nutconfigure.exe at least) and generate the build and
>      Philipp> application trees. So far, everything OK. When I try to build
>      Philipp> the libraries for the first time (i.e. there are no object and
>      Philipp> especially no dep files), the "all" target builds fine. But
>      Philipp> when make wants to take care of the "install" target, it fails:
>
> How does your setup behave for another CM3 arch, like STM32 or LPC?
>

Exactly the same result, tested for the "stm32f4dis_bb.conf" and 
"lisa.conf" platforms. Build succeeds, but afterwards the dep files are 
present and prevent any further invocation of make. Not even make clean 
is possible anymore.

Regards,
Philipp