[En-Nut-Discussion] Unable to configure/make with SVN tree

[Uwe Bonnes]

>>>>> "Bob" == Bob Wirka <bobwirka at yahoo.com> writes:

    Bob> Hello, I've checked out the trunk from the Source Forge Subversion
    Bob> repository, but am unable to configure/make.  The configuration
    Bob> exits after a few seconds with the following (sample snip): ===
    Bob> configuring in nut/tools/crurom
    Bob> (/projects/RTOS/ethernut-SFsvn/trunk/nut/tools/crurom)configure:
    Bob> WARNING: no configuration information is in nut/tools/crurom===
    Bob> configuring in nut/tools/nutconf
    Bob> (/projects/RTOS/ethernut-SFsvn/trunk/nut/tools/nutconf)configure:
    Bob> WARNING: no configuration information is in nut/tools/nutconf===
    Bob> configuring in nut/tools/qnutconf
    Bob> (/projects/RTOS/ethernut-SFsvn/trunk/nut/tools/qnutconf)configure:
    Bob> WARNING: no configuration information is in nut/tools/qnutconf===
    Bob> configuring in nut/tools/nutdisc
    Bob> (/projects/RTOS/ethernut-SFsvn/trunk/nut/tools/nutdisc)configure:
    Bob> WARNING: no configuration information is in nut/tools/nutdisc===
    Bob> configuring in nut/tools/qnutdisc
    Bob> (/projects/RTOS/ethernut-SFsvn/trunk/nut/tools/qnutdisc)configure:
    Bob> WARNING: no configuration information is in nut/tools/qnutdisc A
    Bob> normal configure takes MUCH longer.  I'm able to configure/make the
    Bob> 5.1.0-1 stable version (and others) without issue.  Has anyone seen
    Bob> this?  Thanks, Bob Wirka

Dit you run autogen.sh?

I checkout out a clean directory here (OpenSuse, Linux). autogen.dh called
configure and took some time. I tried make in crurom, nutconf and qnutconf
and all succeeded.

Bye
-- 
Uwe Bonnes                bon at elektron.ikp.physik.tu-darmstadt.de

Institut fuer Kernphysik  Schlossgartenstrasse 9  64289 Darmstadt
--------- Tel. 06151 162516 -------- Fax. 06151 164321 ----------