[En-Nut-Discussion] ethernut-r6130_Change

[kontais at aliyun.com]

Hi,
      I have a stm32f107vc board,  the spi sd driver can't work, I do some changes, hope help for somebody who wan use spi sd on smt32f107.
I change base on svn://svn.code.sf.net/p/ethernut/code/trunk    rev6130


1. C:\Users\kontais\Desktop\Temp\ethernut-r6130_Change\nut\app\Makeburn.cm3-jlink
    jlink burn scripts
2. C:\Users\kontais\Desktop\Temp\ethernut-r6130_Change\nut\app\Makefile
    make clean fix
3.C:\Users\kontais\Desktop\Temp\ethernut-r6130_Change\nut\arch\cm3\board\stm3210c_eval.c
    GPIO use on my board
4.C:\Users\kontais\Desktop\Temp\ethernut-r6130_Change\nut\arch\cm3\dev\stm\stm32_gpioirq.c
   share irq issue, already fixed on new code
5. C:\Users\kontais\Desktop\Temp\ethernut-r6130_Change\nut\arch\cm3\dev\stm\stm32_spi.c
   5.1  delete  SPI_IRQ_MODE, #if SPIBUS_MODE == IRQ_MODE
   5.2  use 10MHz, no 2MHz,   2MHz will error when use POLL_MODE, 
         the root case I don't kown, but find this set cause POLL_MODE error I use three weeks.
static void SetPinSpeed( NUTSPINODE * node, uint32_t rate)
{
#if defined (MCU_STM32F1)
    if (rate_div64k * OSPEED_MULT < ospeed_values[2])
        ospeed_set = 1; /* max speed 10 MHz */
  5.3 rewrite Stm32SpiBusTransfer
           make sure dma and poll can work ok,   can add   "if (xlen * clk_ratio > SCHEDULE_CYCLES/8) {"
           for small transfer use poll.
                            /* Follow procedure "Disabling the SPI" */
                    while(GpioPinGet(SPIBUS_SCK_PORT,SPIBUS_SCK_PIN));      // if use SPI_MODE_3 need this line 
                    while(!(GpioPinGet(SPIBUS_SCK_PORT,SPIBUS_SCK_PIN)));
                    while(GpioPinGet(SPIBUS_SCK_PORT,SPIBUS_SCK_PIN));
6. C:\Users\kontais\Desktop\Temp\ethernut-r6130_Change\nut\dev\spi_mmc.c
    6.1 add CardRelease
         static void CardRelease(NUTSPINODE * node)
    6.2 CardAllocate add wait flag for CMD0
        static NUTSPIBUS *CardAllocate(NUTSPINODE * node, uint8_t wait)
    /* If card has been hot pluged, the card will always out busy, case 
     * allocate wait timeout even you want to send CMD0, so CMD0 no need 
     * to wait.
     */
    if (cmd == MMCMD_GO_IDLE_STATE) {
        wait = 0;
    }
6.3 Add CardReset
     some card need Reset twice
7. C:\Users\kontais\Desktop\Temp\ethernut-r6130_Change\nut\dev\spi_mmc_gpio.c
    use GpioCreateIrqHandler, not GpioRegisterIrqHandler
  SPI_MODE_3 and SPI_MODE_0 are ok.


        





kontais at aliyun.com