[En-Nut-Discussion] Loosing characters on debug interface (uart) using printf

Matthias Ringwald mringwal at inf.ethz.ch
Mon Jun 7 16:41:28 CEST 2004

Hi Ole,

You could try to use/register devUsartAvr0 and use hardware handshake.

devDebug has limited functionality and devUart is 'old'.
so far devUsartAvr0 works fine with the bt module. no chars get lost..


On 07.06.2004, at 15:46, Ole Reinhardt wrote:

> Hi,
>> whole strings were received. If I’m not wrong I had no problem using
>> TeraTermPro instead. Also no problems with any terminal under linux.
> I'm using minicom under linux. I even tried to directly register
> devUart0 instead of devDebug0 (btw: could anyone please explain me the
> difference?). It's working a bit better, but there a still some
> characters lost. I suppose this could perhaps happen while switching 
> the
> thread? This is just an idea.

More information about the En-Nut-Discussion mailing list