[En-Nut-Discussion] Newbie - guide

[Jesper Hansen]

The manual says you need to USE a stk500 compatible programming adapter.

The board itself is not a stk500 programming adapter.

/Jesper


> Hello,
> 
> The hardware manual that I received with the ethernut suggests that
> its a stk500 compatible programming adapter. So I decided to use the
> following commandline parameters with uisp
> 
> uisp  -dprog=stk500 -dserial=/dev/ttyS0 -dpart=ATmega128  --erase -v
> 
> This gives me error -
> 
> <snip>
> Programmer is not responding.
> </snip>
> 
> 
> Any suggestions or clues will be of great help.
> 
> Thanks,
> - Amit Khandelwal