[En-Nut-Discussion] Problem programming EtherNUT

[Harald Kipp]

Hi Carlos,

just stepped into the same trouble. After removing all previous
versions of AVRStudio and installing the latest Ver 4.11.410
with Service Pack 3, I'm unable to program Ethernut 2.1 via
ImageCraft V7 and the new SP Duo Programmer. Grabbing an old
STK500.exe might help...I just have to find one...grrrrr!

How about using the AVRStudio programmer? Does this still
work for you?

You may also create a simple batch file to use uisp. From my
experience these Open Source programmers work quite reliable.

Any other ideas how to overcome this monthly nightmare?

Harald

At 18:31 06.06.2005 +0200, you wrote:
>Hello all,
>
>I have a problem when I try to program a Ethernut 2 rev A board with the
>SISP Hardware.
>
>I used to program it from ICCAVR (version 6.31A) without problems, but
>last friday I deleted AVRStudio from my PC because I needed some extra
>space. Now I have reinstaled it from:
>http://www.atmel.com/dyn/products/tools_card.asp?tool_id=2725
>
>and when I try to program the Ethernut board with the ICCAVR it says:
>
>""C:\Archivos de programa\Atmel\AVR Tools\STK500\Stk500.exe" -z
>-dATMega128 -ccom1
>STK500 command line programmer, v 2.1 Atmel Corp (C) 2004.
>
>Could not connect to STK500 V2 on com1
>Done: there are error(s). Exit code: 1"
>
>I have tried what Harald said in the thread:
>http://www.egnite.de/pipermail/en-nut-discussion/2003-October/001269.html
>
>and when I press ctrl+x it returns:
>SISP 1.1.1  Copyright 2002-2003 by egnite Software GmbH
>
>Anybody can help me please? Is it possible that the stk500.exe version of
>the AVRStudio is not compatible with ICCAVR?
>
>Many thanks in advance and regards,
>Carlos.