[En-Nut-Discussion] Problem programming EtherNUT

[Carlos]

Hi Harald,

I have thought the same, and I have been searching for an old stk500.exe
version. I've found one in:
http://www.avrfreaks.net/index.php?module=FreaksFiles&func=viewFile&id=494&showinfo=1

It is version 1.2, and although this one detects the Programmer, still
fails to programthe micro.

I have not tried the AVRStudio programmer yet.

If I find how to solve the problem I'll say it!!

Can anybody send me his working stk500.exe, please? It is set in the Atmel
directory:

..\Atmel\AVR Tools\STK500\Stk500.exe

Thanks,
Carlos.

> Hi Carlos,
>
> just stepped into the same trouble. After removing all previous
> versions of AVRStudio and installing the latest Ver 4.11.410
> with Service Pack 3, I'm unable to program Ethernut 2.1 via
> ImageCraft V7 and the new SP Duo Programmer. Grabbing an old
> STK500.exe might help...I just have to find one...grrrrr!
>
> How about using the AVRStudio programmer? Does this still
> work for you?
>
> You may also create a simple batch file to use uisp. From my
> experience these Open Source programmers work quite reliable.
>
> Any other ideas how to overcome this monthly nightmare?
>
> Harald
>
> At 18:31 06.06.2005 +0200, you wrote:
>>Hello all,
>>
>>I have a problem when I try to program a Ethernut 2 rev A board with the
>>SISP Hardware.
>>
>>I used to program it from ICCAVR (version 6.31A) without problems, but
>>last friday I deleted AVRStudio from my PC because I needed some extra
>>space. Now I have reinstaled it from:
>>http://www.atmel.com/dyn/products/tools_card.asp?tool_id=2725
>>
>>and when I try to program the Ethernut board with the ICCAVR it says:
>>
>>""C:\Archivos de programa\Atmel\AVR Tools\STK500\Stk500.exe" -z
>>-dATMega128 -ccom1
>>STK500 command line programmer, v 2.1 Atmel Corp (C) 2004.
>>
>>Could not connect to STK500 V2 on com1
>>Done: there are error(s). Exit code: 1"
>>
>>I have tried what Harald said in the thread:
>>http://www.egnite.de/pipermail/en-nut-discussion/2003-October/001269.html
>>
>>and when I press ctrl+x it returns:
>>SISP 1.1.1  Copyright 2002-2003 by egnite Software GmbH
>>
>>Anybody can help me please? Is it possible that the stk500.exe version of
>>the AVRStudio is not compatible with ICCAVR?
>>
>>Many thanks in advance and regards,
>>Carlos.
>
> _______________________________________________
> En-Nut-Discussion mailing list
> En-Nut-Discussion at egnite.de
> http://www.egnite.de/mailman/listinfo.cgi/en-nut-discussion
>