[En-Nut-Discussion] Ethernut not running stable

[Ulrich Prinz]

It doesnt work if Erich is modifying the at91_emac.c/h as his board uses the dm9000e driver. 


Best Regards
Ulrich



-----Original Message-----
From: Harald Kipp <harald.kipp at egnite.de>
To: en-nut-discussion at egnite.de
Sent: Fri, Nov 19, 2010 9:20 am
Subject: Re: [En-Nut-Discussion] Ethernut not running stable


Hi Erich,

On 18.11.2010 22:10, Erich wrote:
> the ethernut 3.0 rev has the dm9000ep on it, shouldnt be the problem there?

I'm a bit confused and can't really follow and find out what you did so far.

You mean you changed

  #define NUT_THREAD_NICRXSTACK   384

to

  #define NUT_THREAD_NICRXSTACK   768

in arch/arm/dev/at91_emac.c? Then you rebuilt the system and the
httpserv binary, right? And the problem still exists.

You are using the same compiler version that was used to test 4.8.8 and
to create the pre-build binaries, so that shouldn't be the problem.

You also tried the ready built binary

 nut\bin\boards\ethernut30e\arm-gcc\httpserv.bin

using the boot loader and it shows the same problem, doesn't it?

Sorry for repeating all this. It's just to make sure, that I got it.

Thanks,

Harald


_______________________________________________
http://lists.egnite.de/mailman/listinfo/en-nut-discussion