[En-Nut-Discussion] Phy initialisation on at91 platform

[Ole Reinhardt]

Hi all,

For most at91 based boards Harald implemented a special board
initialisation in arch/arm/board where the Ethernet PHY will be resetted
with the boot strap pins set correctly.

in arch/arm/dev/at91_emac.c there is still on special initialisation
case left for Davicom PHYs. I would like to move this PHY reset to the
board init as well bot do not want to brake any existing code there...

So is any board depending on this special case in EmacReset() beside of
our eNet-sam7X board?

If no one complains I would create a board init for our board today and
will remove this reset code in at91_emac.c.

Bye,

Ole


-- 

Thermotemp GmbH, Embedded-IT

Embedded Hard-/ Software and Open Source Development, 
Integration and Consulting

http://www.embedded-it.de

Geschäftsstelle Siegen - Steinstraße 67 - D-57072 Siegen - 
tel +49 (0)271 5513597, +49 (0)271-73681 - fax +49 (0)271 736 97

Hauptsitz - Hademarscher Weg 7 - 13503 Berlin
Tel +49 (0)30 4315205 - Fax +49 (0)30 43665002
Geschäftsführer: Jörg Friedrichs, Ole Reinhardt
Handelsregister Berlin Charlottenburg HRB 45978 UstID DE 156329280